Interactive Pen Led Guiding Signals - Dell S300wi User Manual
Hide thumbs
Also See for S300wi:
- User manual (109 pages) ,
- User manual (127 pages) ,
- Firmware upgrade setup manual (12 pages)
Table of Contents
Advertisement
Interactive Pen LED Guiding Signals
Pen Status
Description
Normal mode
Pen faces the
screen with the
link.
Standby mode
Pen doesn't faces
the screen but with
the link.
Finding AP then
Find AP then enter
enter pairing
Pairing mode.
Search mode
When you search
for a channel and
no signal is
available, LED
Green & Amber
will blink 1 time.
Sleep mode
Enter Sleep mode
for power saving
purpose.
Reset
Pairing or linking
failure will perform
the reset
automatically.
Low battery
The pen battery is
capability
low. Two hours are
left to run out of
the battery.
Battery is
The Photo sensor
exhausted and
and RF module
can not run PB.
cannot work
properly. Pen can
not work normally.
110
Troubleshooting Your Projector
Indicator
Green color
Amber color
Solid ON
OFF
Flashing
OFF
0.1s ON/1s OFF
Flashing
Flashing
Flashing
Flashing
0.1 sec.
0.1 sec.
Solid ON
Solid ON
3 sec.
3 sec.
Flashing
Flashing
Flashing
OFF
1s On & 1s OFF
OFF
Solid ON
Checking flow and items / times
Will enter Sleep mode after 3
minutes.
Flash Amber one time, next flash
Green one time, then turn off both.
When you search for a channel and
no signal is available, LED Green &
Amber will blink 1 time.
•Set the Interactive to OFF on
OSD menu when using pen with
the link: will enter Sleep mode
after 5 sec.
•Pen doesn't face the screen but
with the link: will enter Sleep
mode after 3 minutes.
•Reloading the battery will restart
or reset first. After searching for
AP channel 3 cycles without a link,
will enter Sleep mode.
Green and Amber LED flash
alternatively. The total is 3 times.
The MSP430 will check battery
capacity in normal operation. This
alert LED signal is shown if the
battery capacity is low.
Note: This signal is shown only
when pen faces the interactive
screen.
The pen battery is exhausted. Power
only works for MSP430. The alert
LED will appear 1 minute to save
power and then enter Standby
mode. Pen cannot be used in this
status.
Note: This signal is shown only
when the pen faces the interactive
screen.
Advertisement
Table of Contents
