Table of Contents
Advertisement
Steps
1. Place the display assembly on a clean and flat surface.
2. Align and place the palm-rest and keyboard assembly on the display assembly.
3. Using the alignment posts, close the display hinges.
4. Connect the display cable to the system board and adhere the tape to secure the display cable.
5. Place the EDP metal bracket on the display cable connector.
6. Replace the two (M2x3) screw to secure the EDP metal bracket to the system board.
7. Connect the touchscreen cable to the connector on the system board.
8. Replace the six (M2.5x4) screws that secure the display hinge to the chassis of the computer.
9. Route the WWAN cable and the WLAN cable through the retention clips provided.
Next steps
1. Install the
WWAN
card.
2. Install the
WLAN
card.
3. Install the battery.
4. Install the
base
cover.
5. Follow the procedure in
Display bezel
Removing the display bezel
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
WLAN
card.
5. Remove the
WWAN
card.
6. Remove the
display
assembly.
About this task
The figure indicates the location of the display bezel and provides a visual representation of the removal procedure.
110
Disassembly and reassembly
After working inside your
computer.
Before working inside your
computer.
Hide quick links:
Advertisement
Table of Contents
