Table of Contents
Advertisement
Steps
1. Locate the system board slot on your computer.
2. Slide the ports on the system board into the slots on the palm-rest and keyboard assembly and align the screw holes on the system
board with the screw holes on the palm-rest and keyboard assembly.
3. Install the four (M2x3) screws that secure the system board to the palm-rest and keyboard assembly.
4. Align and place the fingerprint reader sensor on to the slot on the computer.
5. Place the finger print reader metal bracket over the finger print sensor.
6. Replace the single (M2x3) screw to secure the metal bracket to the computer.
7. Connect the display cable on to the connector on the system board.
8. Adhere the tape that secures the display board to the system board.
9. Install the two screws (M2x3) that secure the EDP metal bracket to the system board.
10. Connect the keyboard cable to the system board and close the latch to secure the cable.
11. Connect the touchpad cable to the system board and close the latch to secure the cable.
12. Connect the LED board cable to the system board.
Next steps
1. Install the
memory
module.
2. Install the
heat
sink.
3. Install the
inner
frame.
4. Install the
WWAN
card.
5. Install the
WLAN
card.
6. Install the HDD.
7. Install the
solid state
drive.
8. Install the battery.
9. Install the
base
cover.
10. Follow the procedure in
Keyboard
Removing the Keyboard
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
solid state
5. Remove the HDD.
6. Remove the
WLAN
card.
7. Remove the
WWAN
card.
8. Remove the
inner
frame.
9. Remove the
memory
module.
10. Remove the
system
board.
NOTE:
System board can be removed with heatsink attached.
About this task
The figure indicates the location of the keyboard and provides a visual representation of the removal procedure.
After working inside your
computer.
Before working inside your
drive.
computer.
Disassembly and reassembly
89
Hide quick links:
Advertisement
Table of Contents
