Table of Contents
Advertisement
Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly
NOTE:
If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
2. Connect the speaker cable to the system board and route the cable below the I/O board board .
3. Adhere the speaker cable to the palm-rest and keyboard assembly.
4. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE:
Route the speaker cable below the I/O board. Do not route the speaker cable over the solid-state drive bracket.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Front-panel light-board
Removing the front-panel light-board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the speakers.
About this task
The following images indicate the location of the front-panel light-board and provide a visual representation of the removal
procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
29
Advertisement
Table of Contents
