Installing The Heatsink Assembly-Uma - Dell Precision 3541 Service Manual
Hide thumbs
Also See for Precision 3541:
- Setup and specifications manual (42 pages) ,
- Service manual (115 pages)
Table of Contents
Advertisement
Steps
1. Locate the heatsink on your computer.
2. Remove the two (M2x5) and four (M2x3) that secures the heatsink assembly to the computer.
NOTE:
Remove the screws as per the callout on the heatsink module.
3. Disconnect the heatsink fan cable from the system board.
4. Lift the heatsink assembly out of the computer.
5. Remove the single (M2x5) screw that secures the heatsink fan to the heatsink assembly.
6. Lift the heatsink fan from the heatsink assembly.
Installing the heatsink assembly-UMA
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the heatsink assembly and provides a visual representation of the installation procedure.
62
Disassembly and reassembly
Advertisement
Table of Contents
