Port Monitor Commands; Port Monitor - Dell PowerConnect 3424 Cli Reference Manual
Command line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 3424:
- Release notes (9 pages) ,
- User manual (402 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Port Monitor Commands
port monitor
The port monitor Interface Configuration Ethernet mode command starts a port monitoring
session. To stop a port monitoring session, use the no form of this command.
Syntax
port monitor src-interface [rx | tx]
no port monitor src-interface
•
src-interface—Valid Ethernet port. (Full syntax: unit/port)
•
rx—Monitors received packets only.
•
tx—Monitors transmitted packets only.
Default Configuration
Monitors both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
•
This command enables traffic on one port to be copied to another port, or between the source
port (src-interface) and a destination port (port being configured).
•
The following restrictions apply to ports configured as destination ports:
•
The port cannot be already configured as a source port.
•
The port cannot be a member in a port-channel.
•
An IP interface is not configured on the port.
•
GVRP is not enabled on the port.
•
The port is not a member of a VLAN, except for the default VLAN (will automatically be
removed from the default VLAN).
•
The following restrictions apply to ports configured to be source ports:
•
The port cannot be already configured as a destination port.
•
Up to 8 source ports can be configured.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
Port Monitor Commands
239
- Quick Links:
- Introduction
- Ip Addressing
Hide quick links:
Advertisement
Table of Contents
