Table of Contents
Advertisement
CX-JN1
Ver 1.2
QQ
3 7 63 1515 0
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
LASER DIODE AND FOCUS SEARCH OPERATION
CHECK
Carry out the "S curve check" in "CD section adjustment" and
check that the S curve waveforms is output three times.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
TE
L 13942296513
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 ˚C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 ˚C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges oc-
cur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
www
.
4
http://www.xiaoyu163.com
SECTION 1
SERVICING NOTES
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
• MODEL IDENTIFICATION
– Back Panel –
MODEL
CIS model
E, Singapore and Taiwan models
Chilean and Peruvian models
AEP and UK models
Korean and Australian models
Q Q
3
6 7
1 3
1 5
Saudi Arabia model
co
.
9 4
2 8
PART No.
PART No.
4-245-154-4
[]
4-245-201-0
[]
4-245-201-2
[]
4-245-201-3
[]
4-245-201-6
[]
0 5
8
2 9
9 4
2 8
4-245-279-0
[]
m
9 9
9 9
Hide quick links:
Advertisement
Table of Contents
