S e t t i n g s
automatically after a preset time
delay when the phone is in the
standby mode and no function of the
phone has been used. Select On, and
set the time.
When the keyguard is on, calls still
may be possible to the official
emergency number programmed
into your device.
Welcome note
— to write the note
you would like to be shown briefly
when the phone is switched on
Operator selection
set the phone to automatically
select one of the cellular networks
available in your area. With
you can select a network that has a
roaming agreement with your home
network operator.
Confirm SIM serv. actions
services", on page 80.
Help text activation
whether the phone shows help texts
Start-up tone
— to select whether
the phone plays a tone when the
phone is switched on
■ Enhancements
This menu is shown only if the phone
is or has been connected to a
compatible mobile enhancement.
Select
Menu
>
Settings
Enhancements. Depending on the
enhancement, you can select some
of the following options:
50
>
Automatic
— to
Manual
— See
"SIM
— to select
>
Copyright © 2005 Nokia. All rights reserved.
Default profile
— to select the profile
that you want to be automatically
activated when you connect to the
selected enhancement
Automatic answer
phone to answer an incoming call
automatically after 5 seconds. If
Incoming call alert
once
or Off, automatic answer is off.
Lights
— to set the lights
permanently On. Select
to set the lights on for 15 seconds
after a key press.
Ignition detector
automatically switch off the phone
about 20 seconds after you switch
off the car ignition, when the phone
is connected to the full car kit
Text phone
>
Use text phone
to use text phone settings instead of
headset or loopset settings
■ Configuration
You can configure your phone with
settings that are required for certain
services to function correctly. The
services are multimedia messaging,
instant messaging, synchronization,
e-mail application, streaming, push
to talk, and browser. Your service
provider may also send you these
settings. See
"Configuration settings
service", on page ix.
For information on availability and
the appropriate configuration
— to set the
is set to
Beep
Automatic
>
On
— to
>
Yes
—