Advertise Dcbx-Tlv - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

advertise dcbx-tlv

On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.

advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-

reco | pfc] [ets-conf | ets-reco | pfc]

To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.

{ets-conf | ets-

All PFC and ETS TLVs are advertised.

PROTOCOL LLDP

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

You can configure the transmission of more than one TLV type at a time; for

example: advertise dcbx-tlv ets-conf ets-reco.

You can enable ETS recommend TLVs (ets-reco) only if you enable ETS

configuration TLVs (ets-conf). To disable TLV transmission, use the no form of

the command; for example, no advertise dcbx-tlv pfc ets-reco.

DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.

Data Center Bridging (DCB)

Enter the PFC and ETS TLVs advertised, where:

ets-conf: enables the advertisement of ETS

configuration TLVs.

ets-reco: enables the advertisement of ETS

recommend TLVs.

pfc: enables the advertisement of PFC TLVs.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the MXL 10/40GbE Switch IO Module.