Advertisement
Quick Links
Setting Up a PS Series Storage Array
PS4110 Installation
Before You Begin
This is a condensed reference. Read the Installation Guide (provided in the box) for complete installation information.
Register for an EqualLogic Customer Support Account.
If you do not have a customer service support account, go to
Download and Read the Release Notes from the Support Site.
The PS Series Release Notes contain the latest product information.
Review Safety Guidelines.
Be sure to review the safety instructions in your Safety, Environmental, and Regulatory Information booklet.
Prepare For Installation:
Environmental Requirements
Make sure the installation location meets the power, cooling, and ventilation requirements described in the
Installation Guide, located in the shipping box.
Networking Requirements
˗ Standard Ethernet and TCP/IP networking rules apply to a PS Series SAN.
˗ 10 Gigabit Ethernet is required.
Hardware requirements (not supplied)
- Standard 19-inch, four-post rack.
- For Ethernet connections (use only one of the two 10GE ports):
With the 10GBASE-T port, CAT6 (or better) cable for 37 to 55 meters, CAT6A or CAT7 for up to 100 meters.
With the SFP+ port, optical cable or copper SFP+ cable.
- For Management connections (optional): CAT5 cable with RJ45 connector.
1
Unpack the Shipping Box
Caution:
Protect sensitive hardware. Make sure you
use an electrostatic wrist strap or similar form of protection
when handling hardware.
Make sure the shipping box contains the following items:
Setup poster (this document)
Rail kit (if ordered)
Power cables
Electrostatic wrist strap
Documentation
PS Series Storage Array
2
Install the Array in a Rack
Warning!
The array is heavy. Do not attempt to lift the
array without assistance.
Mount the array in a four-post, 19-inch rack. See the rack
instructions that came with the rail kit in your shipping box
(if ordered).
support.dell.com
and create one.
3
Install the Front Bezel
1. Hold the bezel with the array model number and Dell logo upright.
2. Hook the right end of the bezel onto the right side of the chassis.
3. Swing the left end of the bezel towards the left side of the chassis.
4. Press the bezel into place until the release latch closes.
5. Using the provided key, lock the front bezel. Store the key in a safe place.
4
Connect the Power Cables
Caution:
Make sure the power switch is set to off (O) before connecting the power cables.
1. Use the power cables shipped with the array to connect each power supply module to a power source.
Note:
Use separate sources of power, if possible.
2. Use the strain relief fastener to secure the power cables to the power supply modules so they cannot be pulled out accidentally.
If the array was not shipped with power cables, see your PS Series support provider or reseller for power cable information.
See the Installation Guide for more information.
Advertisement
Related Manuals for Dell PS Series
Summary of Contents for Dell PS Series
-
Page 1: Before You Begin
Electrostatic wrist strap Documentation If the array was not shipped with power cables, see your PS Series support provider or reseller for power cable information. PS Series Storage Array See the Installation Guide for more information. Install the Array in a Rack Warning! The array is heavy. - Page 2 Setting Up a PS Series Storage Array (continued) Connect the Array to the Network Hardware Installation is Complete! Recommended Configuration: For high performance and availability distribute the connections across multiple network switches. The Your array hardware should now be up and running. If it is not, make sure that you have successfully completed all of the steps described switches must be connected with interswitch links that have sufficient bandwidth.