Content Index 1. General Safety Instructions ..................3 1.1 SAFETY: General Safety ..................3 1.2 SAFETY: General Power Safety ................5 2. Exploded view diagram with list of items ..............6 3. Wiring connectivity diagram ..................7 4. Disassembly and Assembly Procedures ..............8 4.1 Disassembly SOP ....................
IMPORTANT NOTICE FOR USE IN HEALTHCARE ENVIRONMENTS: Dell products are not medical devices and are not listed under UL or IEC 60601 (or equivalent). As a result, they must not be used within 6 feet of a patient or in a manner that directly or indirectly contacts a patient 1.1 SAFETY: General Safety...
Page 4
When operating your equipment: Do not use your equipment in a wet environment, for example, near a bath tub, sink, or swimming pool or in a wet basement. Do not use AC powered equipment during an electrical storm. Battery powered devices may be used if all cables have been disconnected.
socket. If your equipment uses an AC adapter: Use only the Dell provided AC adapter approved for use with this device. Use of another AC adapter may cause a fire or explosion. NOTE: Refer to your system rating label for information on the proper adapter model ...
4. Disassembly and Assembly Procedures 4.1 Disassembly SOP Preparation before disassembly 1. Clean the room for work 2. Identify the area for material 3. Prepare the implement, equipment, materials as bellow: Working table Philips-head screwdriver Hex-head screwdriver Gloves Cleaning cloth ESD protection Item Picture...
Page 9
1. Pull out CTRL FFC from I/F BD to take off Rear Cover 1. Pull out USB FFC from I/F BD 1. Tear off adhesive tape on Backlight Wire 2. Pull out Backlight Wire from SPS BD 3. Tear off two tapes to disassemble Main SHD from panel - 9 -...
Page 10
1. Pull out LVDS cable and take off Main SHD from panel 1. Disassemble Mylar from 1. Philips-head Main SHD screwdriver Torsion of PCB screw: 8.5±1kgf 2. Hex-head screwdriver Torsion of hex screw: 5±0.6Kgf 2. Unlock 5 PCB screws and 2 hex screws 1.
4.2 Assembly SOP Preparation before assembly 1. Clean the room for work 2. Identify the area for material 3. Prepare the implement, equipment, materials as bellow: 1) Working table 2) Philips-head screwdriver 3) Hex-head screwdriver 4) Gloves 5) Cleaning cloth 6) ESD protection Item Picture...
Page 12
1. Insert LVDS cable into Panel 1. Place Main SHD on panel and paste 2 tapes to fix Main SHD 2. Insert Backlight Wire into SPS BD and paste 1 tape to fix wire 1. Insert USB FFC to USB BD and I/F BD - 12 -...
Page 13
1. Insert CTRL FFC into I/F BD Philips-head screwdriver Torsion of RC screw: 9±1Kgf 2. Assemble Rear Cover with Middle Frame according to the sequence shown in the picture 3. Lock 4 RC screws Assemble Stand a. Insert the stand base blocks fully into the stand slot.