Nokia NPM-6 Series Disassembly And Assembly Instructions
Hide thumbs
Also See for NPM-6 Series:
- Troubleshooting instructions (54 pages) ,
- Manual (50 pages) ,
- Disassembly and assembly instructions (8 pages)
Related Manuals for Nokia NPM-6 Series
Summary of Contents for Nokia NPM-6 Series
- Page 1 NPM-6 Series Transceivers Disassembly and Assembly Instructions Issue 1 01/03 CopyrightãNokia. All rights reserved...
- Page 2 Disassembly and Assembly Instructions CCS Technical Documentation Disassembling instructions .................... 4 Exchange of system connector..................6 Exchange of battery connector..................8 Copyright ãNokia. All rights reserved Page 2 Issue 1 01/03...
-
Page 3: Disassembling Instructions
Note! The screws can be assembled only once. Separate the UI-Module from Radio Module carefully, Use tweezers to remove Vibra Motor. because of the board-to board-connector. Issue 1 01/03 CopyrightãNokia. All rights reserved Page 3... - Page 4 Disassembly and Assembly Instructions CCS Technical Documentation Remove Earpiece. Note the guiding pin when assembling Remove Keymat. Copyright ãNokia. All rights reserved Page 4 Issue 1 01/03...
- Page 5 Press again SRT-6 between C-Cover and System Connector Remove System Connector. and remove System Connector. To remove the remaining adhesive gasket use SRT-6 only. Remove protection foil from System Connector. Do not use sharp-edged tools for this procedure. Issue 1 01/03 CopyrightãNokia. All rights reserved Page 5...
- Page 6 Disassembly and Assembly Instructions CCS Technical Documentation Place System Connector to its guidance exactly. Now press connector to C-Cover firmly, while taking care not to slip C-Cover on your table. Copyright ãNokia. All rights reserved Page 6 Issue 1 01/03...
- Page 7 Note that you need a soldering iron with higher Tin one of pads to fix the connector before soldering the temperature, when cleaning or soldering the grounding following pins. pad. Issue 1 01/03 CopyrightãNokia. All rights reserved Page 7...
- Page 8 Disassembly and Assembly Instructions CCS Technical Documentation Note location of connector pins and support angles to fit Solder first support angle. When position is exactly, solder them precisely. the other pins. Copyright ãNokia. All rights reserved Page 8 Issue 1 01/03...