Table of Contents
Advertisement
CCRt 3650 GTS
Snowthrower
Model No. 38518—Serial No. 250000001 and Up
Introduction
Read this manual carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. The
illustration below identifies the location of the model
and serial numbers on the product. Write the numbers
in the space provided below:
Model #:
Serial #:
This manual identifies potential hazards and has
safety messages identified by the following words:
•
Danger signals an extreme hazard that will
cause serious injury or death if you do not follow
the recommended precautions.
•
Warning signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
•
Caution signals a hazard that may cause minor
or moderate injury if you do not follow the
recommended precautions.
This manual uses 2 other words to highlight
information. Important: calls attention to special
mechanical information and Note: emphasizes
general information worthy of special attention.
Warning
The engine exhaust from this product contains
chemicals known to the State of California to
cause cancer, birth defects, or other reproductive
harm.
E 2004—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
)
Important: This engine is not equipped with a spark
arrester muffler. It is a violation of California Public
Resource Code Section 4442 to use or operate this
engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas
may have similar laws.
Important: The 2-stroke engine provided on this
product meets the EPA Phase I Non-road Emissions
regulations for engines under 19 kW. This product
does not meet CARB TIER 1 regulations and cannot
be sold in California.
This spark ignition system complies with Canadian
ICES-002.
Safety
This snowthrower meets or exceeds the B71.3
specifications of the American National
Standards Institute in effect at the time of
production.
Read and understand the contents of this manual
before the engine is ever started.
m 5515
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol
to avoid possible injury or death.
Improperly using or maintaining this
snowthrower could result in injury or death. To
reduce this potential, comply with the following
safety instructions.
The following instructions have been adapted from
the ANSI/OPEI standard B71.3–1995 and the ISO
8437:1989 standard.
Training
•
Read the operator's manual carefully. Be
thoroughly familiar with the controls and the
proper use of the equipment. Know how to stop
the unit and disengage the controls quickly.
•
Never allow children to operate the snowthrower.
Never allow adults to operate the snowthrower
without proper instruction.
•
Keep the area of operation clear of all persons
(particularly small children) and pets.
•
Exercise caution to avoid slipping or falling.
Printed in the USA
All Rights Reserved
Form No. 3351-836 Rev A
Operator's Manual
Original Instructions (EN)
Register your product at www.Toro.com
Advertisement
Table of Contents
Related Manuals for Toro 38518
Summary of Contents for Toro 38518
- Page 1 Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service This spark ignition system complies with Canadian Dealer or Toro Customer Service and have the model ICES-002. and serial numbers of your product ready. The illustration below identifies the location of the model Safety and serial numbers on the product.
-
Page 2: Maintenance And Storage
The following list contains safety information specific to Toro products or other safety information that you If the unit should start to vibrate abnormally, stop • must know. -
Page 3: Safety/Instruction Decals
Remove the key from the ignition beginning operation. Also, tighten any loose switch before storing the snowthrower. fasteners. • Purchase only genuine Toro replacement parts • Do not smoke while handling gasoline. and accessories. • Do not use the snowthrower on a roof. - Page 4 105-1978 105-1954 3351-836 Rev A...
- Page 5 Etats-Unis : d’après-vente aux Etats-Unis : 1-800-526-6937 1-800-526-6937 The Toro Company Canada: 1-866-854–9033 Bloomington, MN The Toro Company INFORMATION IMPORTANTE CONCERNANT LE MOTEUR Bloomington, MN INFORMATION IMPORTANTE CONCERNANT LE MOTEUR...
-
Page 6: Product Overview
Product Overview Setup Installing the Handle 1. Cut the plastic tie that secures the control cable to the handle. Note: Hold the cable taut to ensure that it stays connected at the bottom. 2. Position the upper handle as shown. m-6230 1. -
Page 7: Installing The Discharge Chute
Mixing Gasoline and Oil m-6187 This snowthrower uses a 50:1 gasoline-to-oil mixture. Installing the Chute Crank Use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added) or an equivalent high-grade, NMMA TCW-certified 1. Insert the end of the chute crank (A) through the two-cycle oil. -
Page 8: Filling The Fuel Tank
Filling the Fuel Tank 4. Start the engine using either the electric-start button or the recoil starter. Fill the fuel tank with a fresh mixture of gasoline and oil mixed at the proper ratio. m-6190 m-6191a m-6106 Operation m-6109a Important: Run the electric starter no more than 10 times at intervals of 5 seconds on, then 5 seconds Note: Determine the left and right sides of the off. -
Page 9: Stopping The Engine
Stopping the Engine Adjusting the Discharge Chute To stop the engine, turn the ignition key counterclockwise to the Off position. To adjust the discharge chute, rotate the chute crank (A) and move the chute deflector handle (B) as shown. m-6192 Starting the Rotor Blades To start the rotor blades, hold the control bar against the handle. -
Page 10: Operating Tips
Throwing Snow • Overlap each swath to ensure complete snow removal. • Discharge the snow downwind whenever Warning possible. • In snowy and cold conditions, some controls and The rotor blades can throw stones, toys, and moving parts may freeze. Do not use excessive other foreign objects and cause serious personal force when trying to operate frozen controls. - Page 11 Adjusting the Control Cable 4. Check the adjustment (refer to Checking the Cable on page 11). Important: Check the control cable for proper Note: After extended use, the drive belt may wear adjustment initially, after the first operating hour, and and lose its proper belt tension.
-
Page 12: Folding The Handle
This can damage the chute handle. 1. Add a fuel stabilizer/conditioner to the fuel in the fuel tank as directed. Note: If you use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added), you do not need to add a fuel stabilizer/conditioner. - Page 13 3351-836 Rev A...
- Page 14 3351-836 Rev A...
- Page 15 You are responsible for presenting your equipment engine to an Authorized Service Dealer as soon as a problem exists. The warranty repairs should be If you think that your Toro Product contains a defect in materials or completed in a reasonable amount of time, not to exceed thirty (30) days.
- Page 16 Instructions for Obtaining Warranty Service If you think that your Toro Product contains a defect in materials or workmanship, or if a normal, able-bodied adult can no longer start your product’s engine in one or two pulls, follow this procedure: 1.