RM-872, RM-873 Version 1.0 For disassembling you need the Nokia Standard toolkit version 2. You will also need an AV plug, a DC plug and the camera removal tool SS-276. Note that the disassembly instructions are made witht the dual SIM variant (RM-872).
Page 4
All manuals and user guides at all-guides.com Release the B-COVER by using the release notch on the bottom of the device. Remove the B-COVER.
Page 5
All manuals and user guides at all-guides.com To remove the A-COVER, first release the clips from the bottom of the device with the SRT-6. Then release the clips from the right side by sliding the SRT-6 along the side.
Page 6
All manuals and user guides at all-guides.com Then release the clips from the left side by sliding the SRT-6 along the side. Then release the top side.
Page 7
All manuals and user guides at all-guides.com Remove the A-COVER. Remove the KEYMAT.
Page 8
All manuals and user guides at all-guides.com Protect the DISPLAY with protective film. Unscrew the six Torx+ size 6 screws in the order shown.
Page 9
All manuals and user guides at all-guides.com To remove the ENGINE BOARD, release the three shown clips with the SS-93. Lift up and remove the ENGINE BOARD.
Page 10
All manuals and user guides at all-guides.com Open the DISPLAY connector with the SS-93. Be careful not to damage the connector or any components nearby. To remove the UI SHIELDING, release the two clips from the shown side.
Page 11
All manuals and user guides at all-guides.com Release also the two clips from the other side. Lift up and remove the UI SHIELDING.
Page 12
All manuals and user guides at all-guides.com Remove the DISPLAY. Place the SS-276 camera removal tool on top of the CAMERA and press down until the CAMERA retaining clips are released. Then hold down the button on top of the SS-276...
Page 13
All manuals and user guides at all-guides.com ...And lift up the CAMERA. Release one corner of the DOMESHEET with the dental tool. Be careful not to injure yourself with the sharp end of the dental tool. Peel off the DOMESHEET with tweezers. Do not use it again. Discard it.
Page 14
All manuals and user guides at all-guides.com Release the AV JACK with an AV plug and remove it with tweezers. Release the DC JACK with a DC plug and remove it.
Page 15
All manuals and user guides at all-guides.com Release the EARPIECE with the dental tool. Remove the EARPIECE with tweezers. Do not use it again. Discard it.
Page 16
All manuals and user guides at all-guides.com If the EARPIECE adhesive remains in the D-COVER, peel it off. Release the 3 IN 1 SPEAKER with the dental tool and remove it with tweezers.
Page 17
All manuals and user guides at all-guides.com Peel off the GASKET on top of the SPEAKER. Do not use it again. Discard it. To remove the ANTENNA MODULE, use the SRT-6 to push down the shown clip.
Page 18
All manuals and user guides at all-guides.com Then release the ANTENNA MODULE from the side and top witht the SRT-6. Remove the ANTENNA MODULE.