Setting Up The Monitor; Attaching The Stand; Connecting Your Monitor - Dell E170S User Manual

Table of Contents

Back to Contents Page

Setting Up the Monitor

Dell™ E170S/E190S Flat Panel Monitor User's Guide

Attaching the Stand

Connecting the Monitor

Organizing Your Cables

Attaching the Soundbar (Optional)

Removing the Stand

NOTE: Stand is detached when the monitor is shipped from the factory.

Remove the monitor cover and place the monitor on it.

1. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.

2. Lower the stand so that the monitor mounting area snaps onto the stand.

CAUTION:

To connect your monitor to the computer perform the following steps/instructions:

1. Turn off your computer and disconnect the power cable.

2. Connect the blue (analog VGA) display connector cable to the corresponding video connector on the back of your computer.

Connecting the blue VGA cable

NOTE:

The Graphics are used for the purpose of illustration only. Appearance of the the computer may vary.

After you have completed connecting the VGA cable, follow the procedure below to complete your monitor setup:

Great user manuals database on

Before you begin any of the procedures in this section, follow the

UserManuals.info

safety

instructions.

Table of Contents

E190s