Distances may vary ±5%. Maximum Tilt Angles Below are the maximum angles that the display can be tilted in both landscape and portrait mode Landscape 20° Portrait 20° www.necvisualsystems.com NEC Corporation of America Page 1 Page 2 Page 3 Page 4 Page 5...
NOTE: The ventilation space should not be covered or closed off at the front of the opening. If for some reason the opening needs to be covered, other means of ventilation will need to be incorporated into the design. Contact NEC for design review and recommendations.
NEC Corporation of America Visual Systems Division P50XC10 Installation Guide 50” Plasma Display Rev 1.0 Display dimensions www.necvisualsystems.com P50XC10 Page 3 of 10...
NEC Corporation of America Visual Systems Division P50XC10 Installation Guide 50” Plasma Display Rev 1.0 Display dimensions (cont.) www.necvisualsystems.com P50XC10 Page 4 of 10...
NEC Corporation of America Visual Systems Division P50XC10 Installation Guide 50” Plasma Display Rev 1.0 Dimensions with optional speakers and stand www.necvisualsystems.com P50XC10 Page 5 of 10...
P50XC10 Installation Guide 50” Plasma Display Optional Speakers and Stand Dimensions Table Top Stand ST-P42C1 www.necvisualsystems.com NEC Corporation of America Visual Systems Division P50XC10 Page 6 of 10 Rev 1.0...
P50XC10 Installation Guide 50” Plasma Display www.necvisualsystems.com NEC Corporation of America Visual Systems Division Optional Speakers SP-P42P1 P50XC10 Rev 1.0 Page 7 of 10...
NEC Corporation of America Visual Systems Division P50XC10 Installation Guide 50” Plasma Display Rev 1.0 Connections Located at Bottom of Display Control Buttons www.necvisualsystems.com P50XC10 Page 8 of 10...
'CR' '0'-'0' 'CR' '0'-'0' 'v'-'P' 'CR' '0'-'0' 'v'-'I' 'CR' '0'-'0' 'v'-'M' 'CR' Command1 Command2 Data length NEC Corporation of America Visual Systems Division Data length Data Notes Message STX-'B'-'1'-ETX STX-'B'-'E'-ETX Item OP code page V-POSITION H-POSITION V-HIGHT H-WIDTH CLOCK PHASE...
NEC Corporation of America Visual Systems Division P50XC10 Installation Guide 50” Plasma Display Rev 1.0 PC Control Connector (D-Sub 9P) NOTE: The only connections required are pins 2 (RxD), 3 (TxD) and 5 (GND). www.necvisualsystems.com P50XC10 Page 10 of 10...