Raid Controller N8103-189/190/191 (Aroc Type-A); Installation - NEC EXP805 User Manual
Hide thumbs
Also See for EXP805:
- Maintenance manual (136 pages) ,
- User manual (262 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
Chapter 2 Preparations
1.16
RAID controller N8103-189/190/191 (AROC Type-a)
This server supports RAID controller PCI board dedicated slot.
Installation
Please prepare the following before installing the option.
Parts included in the option kit
To install the components, follow these steps.
1.
Make sure that the following requirements are met.
Flash Backup Unit has to be fixed to a controller equipped with FBWC feature (N8103-190/191).
When you connect a cable, connect it to a connector of parts following the direction of label attached to
the cable.
Check that the versions of firmware of RAID Controller and SAS Expander are the latest.
2.
See steps 1 to 7 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
RAID controller PCI board dedicated slot
Important
The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/R120h-2M (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
111
Advertisement
Table of Contents
