Table of Contents
Advertisement
10. Replace the screw (M2x4) that secures the right Type-C bracket to the palm-rest and keyboard assembly.
11. Connect the fingerprint reader-board cable to the system board and close the latch to secure the cable.
12. Connect the right speaker cable to the system board.
13. Connect the keyboard cable to the system board and close the latch to secure the cable.
14. Thread the antenna cables through the clips on the system board and connect them to the wireless card.
15. Align the screw hole on the wireless-card bracket with the screw hole on the system board.
16. Replace the screw (M1.6x3) that secures the wireless-card bracket to the system board.
17. Connect the touch screen cable and camera cable to the display-assembly cable .
18. Replace the two screws (M1.6x3) that secure the display-assembly cable holder to the palm-rest and keyboard assembly.
19. Connect the touch screen cable and camera cable to the display-assembly cable.
20. Align the screw holes on the display-assembly cable bracket with the screw holes on the system board.
21. Tighten the three captive screws that secure the display-assembly cable bracket to the system board.
Next steps
1. Install the
I/O
board.
2. Install the
right
fan.
3. Install the
left
fan.
4. Install the
heat
sink.
5. Install the
solid state drive
6. Install the
solid state drive
7. Install the memory.
8. Install the battery.
9. Install the speakers.
10. Install the
base
cover.
11. Follow the procedure in
LED board
Removing the LED board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
battery
4. Remove the
speakers
About this task
The following images indicate the location of the LED board and provide a visual representation of the removal procedure.
2.
1.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
51
Advertisement
Table of Contents
