Table of Contents
Advertisement
DINION 7100i IR
–
–
–
–
–
–
–
–
Camera LED
Click the Enabled or Disabled check-box to switch the Camera LED on or off.
Select Auto disable to let the camera determine when the LED should be switched off.
The camera LED activates when powering on the camera for the first time. The LED
deactivates automatically after 5 min.
Reboot device
Click the Reboot button to restart the device. The entire reboot sequence takes approximately
60 seconds.
Restore settings
Click Restore to restore all settings, except network settings, to their defaults.
Note: Clicking this button also clears the service-level password. Operators must reset the
password before doing anything else.
Factory defaults
Click Defaults to restore all settings, including passwords and network settings, to their
defaults.
Note: Clicking this button also clears the service-level password. Operators must reset the
password before doing anything else.
4.4.2
Display Stamping
Various overlays or stamps in the video image provide important supplementary information.
These overlays can be enabled individually and arranged on the image in a clear manner.
The drop-down menus below allow the configuration of the individual stamping options. The
respective sample windows show a preview of the configured text and background styles.
Bosch Security Systems B.V.
Set lens to default position
–
Select Default to set the lens to its default position.
Optical zoom
–
Use the slider to adjust the optical zoom.
Autofocus
–
Select either Local Range (preferred selection) or Full Range (backup selection) to
automatically focus the image.
Focus position
–
Use the slider to adjust the focus position. The focus position automatically adjusts
to the autofocus.
Focus indicator
–
The Focus indicator shows a value related to the focus quality of the image. The
higher the value, the more in focus the image will be.
Lens
–
Indicates the lens type in use.
IR-corrected lens
–
Click the checkbox to activate or deactivate IR correction function.
The setting of the lens mode is crucial to ensure optimal performance. In daylight
operation, the IR-corrected mode is not required. In dark environments where the
majority of light is provided by the IR illuminators, the lens should be set to IR-
corrected mode. Otherwise, if sufficient ambient light is available, disable the IR-
corrected mode. An incorrect lens setting could result in improper focusing.
Electronic image stabilization crop [%]
–
Use the slider to adjust the percentage of the image cropped to compensate for any
movements caused by vibration or oscillation. A higher image crop percentage allows
for greater movement compensation.
User manual
Configuration | en
2023-06 | V02 | F.01U.390.686
21
Advertisement
Table of Contents
