Table of Contents
Advertisement
Installing the Palmrest Assembly
1. Place the palmrest on the chassis and press the notches until it clicks in place.
2. Connect the touchpad and power cables to the system board.
3. Tighten the screws to secure it to the system board.
4. Turn the computer over and tighten the screws at the base of the computer.
5. Install:
a)
keyboard
b)
memory module
c)
hard drive
d)
WLAN card
e)
access panel
f)
optical disk-drive
g)
battery
6. Follow the procedures in
Removing the Coin-Cell Battery
1. Follow the procedures in
2. Remove:
a)
battery
b)
optical disk-drive
c)
access panel
d)
hard drive
e)
memory module
f)
keyboard
g)
palmrest assembly
3. Push the coin-cell release latch using a scribe and then pull the coin-cell battery to remove it from the computer.
16
Removing and Installing Components
After Working Inside Your
computer.
Before Working Inside Your
Computer.
Advertisement
Table of Contents
