Display Latch; Installing The Display Panel; Removing The Display Latch - Dell Precision M20 Service Manual
Dell precision m20 service manual
Hide thumbs
Also See for Precision M20:
- Quick reference manual (168 pages) ,
- User manual (116 pages) ,
- Quick reference manual (112 pages)
Table of Contents
Advertisement
3
M2 x 3-mm screws (4)
8. Remove the display panel from the top cover.
9. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
1 top flex-cable connector
2 top display-cable connector
3 pull-tab on bottom flex-cable
connector
10. Press in both sides of the top display cable connector, and pull the display cable connector away from the top flex-cable connector.
Installing the Display Panel
1. Connect the top display cable connector to the top flex-cable connector.
2. Connect the bottom flex-cable connector to the inverter connector.
3. Replace the display panel inside the top cover.
4. Tighten the four M2 x 3-mm screws (two on each side) around the display panel.
5. Replace the
display bezel.
Display Latch
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
Removing the Display Latch
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the
center control
cover.
3. Remove the keyboard.
4. Remove the
display
assembly.
5. Remove the
display
bezel.
6. Remove the M2.5 x 5-mm screw that secures the display latch to the top cover.
6M871 (flex cable, top flex-cable
connector, and pull-tab)
Advertisement
Table of Contents
