Table of Contents
Advertisement
Windows Server 2003 Clean Installation
This section explains how to perform a clean installation of Windows Server 2003.
1.
Turn on the system power.
2.
Insert the Windows Server 2003 CD-ROM in the CD-ROM drive.
3.
Press Ctrl + Alt + Delete to reset the system.
After a bootable operating system has been installed on the hard disk, press Enter while
the message "Press any key to boot from CD..." is displayed at the top of the screen.
If no bootable operating system exists on the hard disk, this step is unnecessary.
The Windows Server 2003 setup screen will appear.
If the screen is not displayed, Enter was not pressed properly.
Begin after turning on the system power again.
4.
Press F6 while the message "Setup is inspecting your computer's hardware
configuration..." is displayed at the upper part of the screen.
NOTE:
– "Setup is inspecting your computer's hardware configuration ..." is displayed.
– A screen with a solid blue background is displayed.
IMPORTANT: There is no visible indication on screen when F6 has
been pressed.
5.
When the following message is displayed, press S.
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices.
The following message is displayed.
6.
Insert the Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER into the
floppy disk drive, and press Enter.
A list of mass storage devices is displayed.
Select the [Adaptec Ultra320 SCSI Cards (Win XP/Server 2003 IA-32)] and press Enter.
Then, it returns to the screen of Procedure 5.
Nothing is changed on the screen through F6 is pressed.
Please insert the disk labeled
manufacturer-supplied hardware support disk
*Press ENTER when ready.
Installing Windows Server 2003 D-5
into Drive A:
Advertisement
Table of Contents
Troubleshooting
