(gas type and pressure) and the adjustment of the appliance are compatible. • The adjustment conditions for this appliance are de- scribed on the label (or data plate). • Information about the gas supply is on the rating plate. www.zanussi.com...
Page 3
• Do not close the lid until the hob and oven are com- • Do not put flammable products or items that are wet pletely cold. with flammable products, and/or fusible objects (made www.zanussi.com...
• If you use an oven spray, follow the instructions from the manufacturer. Do not spray anything on the heating elements and the thermostat sensor (if applicable). Product description General overview Control panel Knobs for the hob Knob for the oven functions Rating plate Shelf levels www.zanussi.com...
Always light the burner before you put cookware on Ignition of the burner To light the burner: Warning! Be very careful when you use open fire in Put the flame near the burner. a kitchen environment. The manufacturer declines responsibility if the flame is misused. www.zanussi.com...
Burner Diameters of cookware Rapid 160 mm - 240 mm Hob - Care and cleaning Warning! Refer to "Safety information" chapter. Warning! Switch the appliance off and let it cool down before you clean it. www.zanussi.com...
Turning off the oven burner imum setting. To put out the flame, turn the knob to the off position. When the flame comes on, keep the gas oven control knob pushed for approximately 15 seconds. www.zanussi.com...
• To prevent too much smoke in the oven during roast- when you cook. This can change the baking results and ing, add some water into the dripping pan. To prevent damage the enamel coating. the smoke condensation, add water each time after it dries up. www.zanussi.com...
It can destroy nonstick coating! break. To prevent this you must replace them. For more instructions, contact your local Service Centre. www.zanussi.com...
The burner crown is blocked with Make sure that the injector is not food residue. blocked and the burner crown is clear of food particles. The oven does not heat up. The oven is not activated. Activate the appliance. www.zanussi.com...
If one or more defects are visible, do not repair the pipe, Installation: use the pipe holder. Always engage the gas- but replace it. ket. Then continue with the gas connection. The flexible pipe is prepared for apply when: www.zanussi.com...
Page 14
Warning! Before replacing the injectors, make sure that the gas knobs are in the off position. Let the appliance cool off fully. There is a risk of injury. Injectors replacement Replace the nozzles when changing the gas type. Remove the pan supports. www.zanussi.com...
Les condi- vention by third parties or the use of non-genuine compo- tions de garantie ne sont pas valables en cas d’interven- nents. tion d’un tiers non autorisé, de l’emploi de pièces de re- www.zanussi.com...