Page 1
BT2.1 + EDR & stereo audio Transceiver with BL-6Q battery pack Talk time Standby Note Up to 8 h Up to 300 h Depends on 2G/3G network Up to 4 h parameters and phone settings ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
New assembly hints added The purpose of this document is to help NOKIA service levels 1 and 2 workshop technicians to carry out service to NOKIA products. This Service Manual is to be used only by authorized NOKIA service suppliers, and the content of it is confidential. Please note that NOKIA provides also other guidance documents (e.g.
Nokia operates a policy of continuous development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.
3. Use only approved components as specified in the parts list. 4. Ensure all components, modules screws and insulators are correctly re–fitted after servicing and alignment. 5. Ensure all cables and wires are repositioned correctly ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
6700 classic RM-470 Service Manual Level 1&2 4. ESD PROTECTION Nokia requires that service points have sufficient ESD protection (against static electricity) when servicing the phone. Any product of which the covers are removed must be handled with ESD protection. The SIM card can be replaced without ESD protection if the product is otherwise ready for use.
• modifications or attachments could damage the phone and may violate regulations governing radio devices. All of the above suggestions apply equally to the product, battery, charger or any accessory. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Batteries’ performance is particularly limited in temperatures well below freezing. Do not dispose batteries in a fire! Dispose of batteries according to local regulations (e.g. recycling). Do not dispose as household waste. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
6700 classic RM-470 Service Manual Level 1&2 7. EXPLODED VIEW See corresponding ITEM/CIRCUIT REF in the Spare Parts Service Bulletins on NOL. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
6700 classic RM-470 Service Manual Level 1&2 8. SERVICE DEVICES FLS-5 Flash Device AC-8 Charger BL-6Q Internal Battery CA-101 Service Cable SS-209 camera removal tool RJ-230 Universal Soldering Jig ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 11
For more information, refer to the Service Bulletin (SB-011) on Nokia Online. Supplier or manufacturer contacts for tool reorder can be found in the “Recommended service equipment” document in Nokia Online. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Flash concept – (Point of Sales) To use the FLS-5 Flash Dongle, you have to follow the user guide inside the sales package. Please check always for the latest version of flash software, which is available on Nokia Online. ISSUE 3 Confidential Copyright @ 2008 NOKIA.
Service Manual Level 1&2 10. DISASSEMBLY INSTRUCTIONS Slide the BATTERY COVER into the direction shown in Remove the BATTERY COVER. the picture. If necessary, also remove the battery… ... and memory card. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 14
Unscrew the 4 Torx 4 + screws on the top and on the Release the D COVER ASSEMBLY using the SRT-6 tool. bottom. Start at one of the bottom edges. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 15
Work around the whole D COVER to release it. Be careful Remove the D COVER. of the key connectors when opening the D-COVER. Release the A COVER clips on both sides using the Dental Tool. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 16
Separate the UI KEYMAT by gently pushing from the A COVER ASSEMBLY outwards. Remove the UI KEYMAT by lifting it upwards. Separate the MAIN KEYMAT from the A COVER ASSEMBLY. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 17
Release the MAIN KEYMAT GROUND SPRING on the left side of the phone… …and remove it. Fix the VOLUME KEY ROCKER ARM with a protection foil. NOTE: Also protect the LCD with a protection foil to avoid scratches. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 18
Release the snaps of the ANTENNA ASSEMBLY on both sides... …and remove it. Release the LCD carefully from both the left and the right side with the Dental Tool as shown in the picture. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 19
It is therefore necessary to transfer the copper tracks from the spare foil to the C COVER. The tracks can be straightened out using the flat end of the SS-93 tool. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 20
Release the connector of the UI FLEX MECH ASSEMBLY Release the CAMERA using the camera removal tool SS- using the SS-93 tool. 209. Remove the CAMERA. Remove the 4 screws holding the PWB shield. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 21
Lift up the PWB together with the PWB LID ASSEMBLY and AV Flex Mech Assembly. Release the AV FLEX MECH ASSEMBLY connector using Separate the AV FLEX MECH ASSEMBLY from the PWB. the SS-93 tool. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 22
… and remove it. Peel off the UI FLEX MECH ASSEMBLY. You can use the SS-93 tool to release the connectors as Remove the UI FLEX MECH ASSEMBLY. show in the picture. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
Page 23
6700 classic RM-470 Service Manual Level 1&2 Release the DC Connector using a charger plug. End of disassembly ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
When mounting the A COVER, make sure that the A COVER hooks are correctly in place on the C COVER. If necessary, press the hooks towards the C COVER after the A COVER is mounted. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...
6700 classic RM-470 Service Manual Level 1&2 11.1 Screw order and torque Tighten the screws to the torque of 10 Ncm in the order shown. ISSUE 3 Confidential Copyright @ 2008 NOKIA. All rights reserved...