Ipv6 Neighbor Discovery - Dell Z9000 Configuration Manual

10/25/40/50/100gbe throughput

Hide thumbs Also See for Z9000:

Table of Contents

Figure 42. Path MTU Discovery Process

IPv6 Neighbor Discovery

NDP is a top-level protocol for neighbor discovery on an IPv6 network. In lieu of address resolution

protocol (ARP), NDP uses "Neighbor Solicitation" and "Neighbor Advertisement" ICMPv6 messages for

determining relationships between neighboring nodes. Using these messages, an IPv6 device learns the

link-layer addresses for neighbors known to reside on attached links, quickly purging cached values that

become invalid.

NOTE: If a neighboring node does not have an IPv6 address assigned, it must be manually pinged to

allow the IPv6 device to determine the relationship of the neighboring node.

NOTE: To avoid problems with network discovery, Dell Networking recommends configuring the

static route last or assigning an IPv6 address to the interface and assigning an address to the peer

(the forwarding router's address) less than 10 seconds apart.

With ARP, each node broadcasts ARP requests on the entire link. This approach causes unnecessary

processing by uninterested nodes. With NDP, each node sends a request only to the intended destination

via a multicast address with the unicast address used as the last 24 bits. Other hosts on the link do not

participate in the process, greatly increasing network bandwidth efficiency.

IPv6 Routing