File Transfer Services; Configuration Task List For File Transfer Services; Enabling The Ftp Server - Dell Z9000 Configuration Manual

10/25/40/50/100gbe throughput

Hide thumbs Also See for Z9000:

Table of Contents

Add timestamp to syslog messages.

CONFIGURATION mode

service timestamps [log | debug] [datetime [localtime] [msec] [show-timezone]

Specify the following optional parameters:

– You can add the keyword localtime to include the localtime, msec, and show-timezone. If

you do not add the keyword localtime, the time is UTC.

– uptime: To view time since last boot.

If you do not specify a parameter, Dell Networking OS configures uptime.

To view the configuration, use the show running-config logging command in EXEC privilege mode.

To disable time stamping on syslog messages, use the no service timestamps [log | debug]

File Transfer Services

With Dell Networking OS, you can configure the system to transfer files over the network using the file

transfer protocol (FTP).

One FTP application is copying the system image files over an interface on to the system; however, FTP is

not supported on virtual local area network (VLAN) interfaces.

For more information about FTP, refer to RFC 959, File Transfer Protocol.

NOTE: To transmit large files, Dell Networking recommends configuring the switch as an FTP

The configuration tasks for file transfer services are:

Enable FTP Server

Configure FTP Server Parameters

Configure FTP Client Parameters

To enable the system as an FTP server, use the following command.

To view FTP configuration, use the show running-config ftp command in EXEC privilege mode.

Enable FTP on the system.

CONFIGURATION mode

ftp-server enable

Example of Viewing FTP Configuration

Dell#show running ftp

ftp-server enable