Table of Contents
Advertisement
Attaching the Center Slide Bar to the Server
Using the two center slide bars removed in the previous procedure attach them
to the server as follows:
1. Align the mounting holes in each slide bar to the threaded holes on the side
of the server (see Figure 2-3).
Note:
one way with the holes in the server.
2. Secure each slide bar to the server using three M4 screws, as shown in
Figure 2-3.
Note:
of the server you must remove the three plastic screw hole
covers from the threaded screw holes in the server.
Figure 2-3. Attaching the Inner Component Slide Bar to the server
Installing the Rack Mounting Bracket Assemblies into the Rack Cabinet
Before you can mount the server in the rack cabinet, you must install the Rack
Mounting Bracket Assemblies in the rack cabinet.
Note:
the rack cabinet before mounting the server into it. Observe
all safety precautions, warnings, and cautions noted
throughout this chapter.
The holes in the two center slide bars line up only
Before securing a slide bar on the right-hand side
A – Center Slide Bar
B – Safety Latch
C – M4 Screws (1 of 3)
D – Threaded Holes in server
You must use the following procedure to prepare
Setting Up the System 2-7
Advertisement
Table of Contents
Troubleshooting
