3 Multimeter or DVM. 4 GSM radio telephone test station or separate measuring equipment as follows: • RF generator • pulse power meter • spectrum analyzer • attenuator and branching unit Nokia Mobile Phones Ltd. Issue 4 03/01 Page 5...
When the phone covers are removed, the jigs should be used. For audio measurements, connect the audio cable (ADS-1) as follows: • EAR line to AF INPUT of test equipment • MIC line to MOD GEN OUTPUT of test equipment Nokia Mobile Phones Ltd. Page 6 Issue 4 03/01...
WinTesla Service SW application 0774046 The nominal operating voltage for JBS-19 is 3.6 V. The supply voltage for JBS-19 must never exceed 5.0 V. SCH-5, JBA-4, and DAU-9S can be replaced with DAU-9P Recommended Nokia Mobile Phones Ltd. Page 12 Issue 4 03/01...
WinTesla Service SW application 0774046 The nominal operating voltage for JBT-1 is 3.6 V. The supply voltage for JBT-1 must never exceed 5.0 V. SCH-5, JBA-4, and DAU-9S can be replaced with DAU-9P Recommended Nokia Mobile Phones Ltd. Issue 4 03/01 Page 13...
5 Select the “Transfer user data?” option and press OK. The next prompt is: “Con- firm transfer?” Press OK again. 6 Wait until the transfer is completed. 7 Turn off phone No. 2, then turn it on again. Check the Welcome note and profile Nokia Mobile Phones Ltd. Page 14 Issue 4 03/01...
Press the OK button when the center frequency is correct. 2. VCTCXO Tuning This tuning is used to verify that the radio unit has the correct adjustment to meet a net- Nokia Mobile Phones Ltd. Issue 4 03/01 Page 15...
Follow the steps as described here: • Select Tuning>TX I/Q • Connect the spectrum analyzer to the phone antenna connector (use attenuator, if needed). Nokia Mobile Phones Ltd. Page 16 Issue 4 03/01...
Page 17
CHF -67 kHz is >35 dB. • Select the Phase Difference option from the “Tuning” drop-down menu. • Adjust the level of signal CHF +67.7 kHz to minimum by varying D/A Nokia Mobile Phones Ltd. Issue 4 03/01 Page 17...
Adjust the power level by clicking the + and - buttons; change the levels using the up arrow and down arrow keys. • Tune power levels 2, 7, and 9. • Use the Calculate button to calculate all other levels. Nokia Mobile Phones Ltd. Page 18 Issue 4 03/01...
Check that the power level PL2 TXC DAC value is within the allowed range (-50...200). * Note if there is a difference between the power measured from the panel test pad and the Ext. RF connector when calcu- lating measurements from Ext. RF. Nokia Mobile Phones Ltd. Issue 4 03/01 Page 19...
Repeat this measurement for all signal levels. • Press the OK button when the tuning is correct. 7. RSSI Analog This measurement is used for RSSI in analog mode. The analog mode works only with 800 MHz. Nokia Mobile Phones Ltd. Page 20 Issue 4 03/01...
Press the OK button when the tuning is correct. 10. Charging Perform the following steps: • Select Tuning>Charging • Connect the service battery to the phone and DC cable (SCB-3) between phone and service battery. Nokia Mobile Phones Ltd. Issue 4 03/01 Page 21...
Page 22
PAMS Technical Documentation • Set the supply voltage to 10.5 V. • Run calibrations all at once by pressing the Meas button. • Set the supply voltage back to 8.4 V. Nokia Mobile Phones Ltd. Page 22 Issue 4 03/01...