Nokia NSM-3 Series Disassembly & Troubleshooting Instructions
Hide thumbs
Also See for NSM-3 Series:
- Service manual (342 pages) ,
- Technical documentation manual (120 pages) ,
- Tuning instructions (24 pages)
Related Manuals for Nokia NSM-3 Series
Summary of Contents for Nokia NSM-3 Series
- Page 1 PAMS Technical Documentation NSM–3/3D Series Transceivers Disassembly & Troubleshooting Instructions E Nokia Mobile Phones Ltd. Issue 3 11/2000...
-
Page 2: Table Of Contents
........E Nokia Mobile Phones Ltd. -
Page 3: Disassembly Of Nsm-3
Remove A–cover. Step 1. Press the button on the top of the phone. Step 2. Pull A–cover apart. NOTE snap fixings at the lower end of A–cover. E Nokia Mobile Phones Ltd. Page 3 Issue 3 11/2000... - Page 4 NOTE: When assembling make sure UI and PCB module edges are fitted also correctly. Remove the speaker from its housing. NOTE: Install allways new speaker, old speaker must not be used. E Nokia Mobile Phones Ltd. Page 4 Issue 3 11/2000...
- Page 5 B–cover housing. Remove the bat- tery connector from its housing using SRT–3 tool. Remove the antenna by releasing the snap fixings at both sides of the phone. E Nokia Mobile Phones Ltd. Page 5 Issue 3 11/2000...
- Page 6 NSM–3/3D PAMS Technical Documentation Disassembly & Troubleshooting Instructions Remove the SIM spring by releasing the fixings at both ends of the spring. Main parts of the phone disassembled. E Nokia Mobile Phones Ltd. Page 6 Issue 3 11/2000...
-
Page 7: Disassembly Of Nsm-3D
Remove A–cover. Step 1. Press the button on the top of the phone. Step 2. Pull A–cover apart. NOTE snap fixings at the lower end of A–cover. E Nokia Mobile Phones Ltd. Page 7 Issue 3 11/2000... - Page 8 NOTE: When assembling make sure UI and PCB module edges are fitted also correctly. Remove the speaker from its housing. NOTE: Install allways new speaker, old speaker must not be used. E Nokia Mobile Phones Ltd. Page 8 Issue 3 11/2000...
- Page 9 B–cover housing. Remove the bat- tery connector from its housing using SRT–3 tool. Remove the antenna by releasing the snap fixings at both sides of the phone. E Nokia Mobile Phones Ltd. Page 9 Issue 3 11/2000...
- Page 10 NSM–3/3D PAMS Technical Documentation Disassembly & Troubleshooting Instructions Remove the SIM spring by releasing the fixings at both ends of the spring. Main parts of the phone disassembled. E Nokia Mobile Phones Ltd. Page 10 Issue 3 11/2000...
-
Page 11: Transceiver Troubleshooting
MAD (D200) –> COMBO MEMORY (D210) J237 SYNTHDATA HAGAR (N505) SERIAL DATA (SDATA) MAD (D200) –> HAGAR (N505) J239 DSPXF NOT CONNECTED J240 MCURDX MCU READ MAD (D200) –> COMBO MEMORY (D210) E Nokia Mobile Phones Ltd. Page 11 Issue 3 11/2000... - Page 12 VIBRA DRIVE UI–SWITCH (N310) –> VIBRA (M300) N310 PIN 19 VIBRA VIBRA CONTROL PWM MAD (D200) –> UI–SWITCH (N310) N310 PIN 3 BUZZER BUZZER CONTROL PWM MAD (D200) –> UI–SWITCH (N310) E Nokia Mobile Phones Ltd. Page 12 Issue 3 11/2000...
-
Page 13: Testing
A/D reading is also zero. Now the slope is known and A/D readings can be calibrated. Calibration is included in VBATT A/D reading task. E Nokia Mobile Phones Ltd. Page 13 Issue 3 11/2000... -
Page 14: Troubleshooting
– solder joints are OK Before changing anything ALL SUPPLY VOLTAGES AND SYSTEM CLOCK / SLEEP CLOCK should be checked. Clock signal 26MHz VCXO buffer G830 V800++ 13MHz HAGAR N505 C213 E Nokia Mobile Phones Ltd. Page 14 Issue 3 11/2000... -
Page 15: System Clock
Check the signal from the RF side Change the Hagar oskilator VCXO G830 output from N505 C833. There should be 26MHz signal. IF THERE ISN’T Change the VCXO G830 System clock picture. E Nokia Mobile Phones Ltd. Page 15 Issue 3 11/2000... -
Page 16: Sleep Clock
Layout picture B signal Clk 32kHz, should be like in SLEEP CLOCK picture. IF NOT Check R100, R154, R102, C102, C101, C113 and B100 IF OK Change the CCONT N100 Sleep clock picture. E Nokia Mobile Phones Ltd. Page 16 Issue 3 11/2000... -
Page 17: Power Supplies
PAMS Technical Documentation Disassembly & Troubleshooting Instructions Power Supplies Measure power supplies. Test points are shown in layout picture A. Layout shown here is NSM–2. Vbat Vcore Vsyn2 Vsyn1 Vcobba Vref E Nokia Mobile Phones Ltd. Page 17 Issue 3 11/2000... - Page 18 Cconts digital parts keep MAD in reset by keeping PURX down for a delay of 62ms. Here is shown the start up sequence picture. Ch1 = Vbb Ch2 = VXO Ch3 = SleepClk Ch4 = PURX (see picture B) E Nokia Mobile Phones Ltd. Page 18 Issue 3 11/2000...
- Page 19 NSM–3/3D PAMS Technical Documentation Disassembly & Troubleshooting Instructions CLK 32 kHz PURX Ccont int. VXO Pwr ESysResetX FBUSTx MCUAd1 MCUWrX FBUSRx MBUS ROM1SelX MCURdX E Nokia Mobile Phones Ltd. Page 19 Issue 3 11/2000...
-
Page 20: Phone Is Totally Dead
MCU self tests are devided to those executed while power up (start up tests) and ones that can be executed with connected PC. The tests and included items are as follows: E Nokia Mobile Phones Ltd. Page 20 Issue 3 11/2000... - Page 21 A. Power off B. Security data C. EEPROM tune checksum D. PPM checksum E MCU download DSP F. DSP alive G. COBBA serial H COBBA parallel I. EEPROM checksum K. PPM validity E Nokia Mobile Phones Ltd. Page 21 Issue 3 11/2000...
-
Page 22: Sim Related Faults
IF NOT OK Check the Vsrm (C131 RF side head) Change the CCONT N100 V5V (C108 bottom connector side head) IF NOT OK Check the regulator N600, V116, C132 and C131 E Nokia Mobile Phones Ltd. Page 22 Issue 3 11/2000... -
Page 23: Audio Faults
Check the voltage in resistor Check R266, C268, L287 and V250 R267 RF side head. Voltage should be about 2.1V Check the R268,C 274,C263,C278 Change the COBBA N250 and C262 E Nokia Mobile Phones Ltd. Page 23 Issue 3 11/2000... - Page 24 Change the COBBA N250 Headset earphone doesn’t work and there isn’t any mechanical problem Check R 257,R256, R270, L284, L283 C284, C283, C 296, C 297, C261and C255 Change the COBBA N250 E Nokia Mobile Phones Ltd. Page 24 Issue 3 11/2000...
-
Page 25: Charging Fault
Display ” not charging” Check charge voltage with wintesla Check F101, V100,R104 and R103 Check charge current with wintesla IF NOT OK Check V101 and R131 Change the Chaps N101 E Nokia Mobile Phones Ltd. Page 25 Issue 3 11/2000... -
Page 26: Rf Troubleshooting
TCXO/2 (13 MHz) TX_balout(GSM) RX_GSM (balun_in) Vchp 1.35V (RX) VCO_out 1.2V (RX) RXI (filt) TCXO (26 MHz) VCO_ctrl RXQ (filt) RX I/Q (ADC) Vsynte Vtcxo Vlna +1.5V Vmod Vcobba Vrxrf E Nokia Mobile Phones Ltd. Page 26 Issue 3 11/2000...