Content Index 1. General Safety Instructions ..................3 1.1 SAFETY: General Safety ..................3 1.2 SAFETY: General Power Safety ................5 2. Exploded view diagram with list of items ..............6 3. Wiring connectivity diagram ..................8 4. How to connect and disconnect power cable/ connectivity cable......9 5.
IMPORTANT NOTICE FOR USE IN HEALTHCARE ENVIRONMENTS: Dell products are not medical devices and are not listed under UL or IEC 60601 (or equivalent). As a result, they must not be used within 6 feet of a patient or in a manner that directly or indirectly contacts a patient 1.1 SAFETY: General Safety...
Page 4
if all cables have been disconnected. Do not spill food or liquids on your equipment. Before you clean your equipment, disconnect it from the electrical outlet. Clean your device with a soft cloth dampened with water. Do not use liquids or aerosol cleaners, which may contain flammable substances.
Be sure to grasp the plug, not the cable, when disconnecting equipment from an electric socket. If your equipment uses an AC adapter: Use only the Dell provided AC adapter approved for use with this device. Use of another AC adapter may cause a fire or explosion.
2. Exploded view diagram with list of items ○ ○ ○...
Page 7
SCREW M3*3L not for SCREW M3*6L other regions SCREW M4 PWD MYLAR POWER BOARD MAINBOARD MAINFRAME QR-SLIDER QR-BUTTON SPRINGS KEY BOARD BUTTON REAR COVER DELL LOGO SCREW M4*10L Hinge ass’y Base ass’y Power Cable See “NOTE" DP 1.2 cable See “NOTE"...
Page 8
See “NOTE" NOTE: For replacement of power cord, connectivity cable and external power supply (if applicable), contact Dell: 1. Go to https://www.dell.com/support. 2. Verify your country or region in the Choose A Country/Region drop-down menu at the bottom-right corner of the page.
4. How to connect and disconnect power cable/ connectivity cable...
Page 12
5. Mechanical Instruction NOTE: This “Disassembly and Assembly Procedures” is for EMEA only, not for other regions. Please note that Dell will deem warranty void if any disassembly is done on the monitors. Tools Required List the type and size of the tools that would typically can be used to disassemble the product to a point where components and materials requiring selective treatment can be removed.
Page 13
5.1Disassembly Procedures Step Figure TOOl Remark Push the button and pull out the stand. Note: Put the monitor on a flat, soft and clean surface. Remove the Base ass’y. Unscrew the 4 screws by the Philips-head Screwdriver. Torque=6±1kgf.cm Remove the Take scraper insert Rear cover the bezel bottom site...
Page 14
Disconnect Remove the the FFC connectors and tapes cables and LVDS cabel. Tear out all the tapes. Unscrew the 2 screws on the USB board and mainframe. Remove the mainframe Torque=6±1kgf.cm Tear out the wires and mylar. remove the screws on the board by the Philips-head.
Page 15
Remove the Unscrew the plastic mainboard screws on the mylar and power board Mainboard powerboard Unscrew the screws Remove the on the middle frame middle frame...
Page 17
5.2 Assembly Procedures Assemble screw the screws on middle the middle frame frame push the screws by Assemble hand the maylar Tighten the screws on the board Assemble mainboard powerboard...
Page 18
Connect all connect the connectors and tapes. FFC cables Tighten the screw on and LVDS the baord cabel. Tighten the 4 screws Assemble by the Philips-head Screwdriver. the rear Torque=6±1kgf.cm cover Assemble the stand ass’y...