Table of Contents
Advertisement
Connecting the monitor for DPBS for the first time
For the first time setting up the DPBS function, please follow below steps:
1. Make sure both the PC and the monitor are OFF.
2. Press the monitor power button to turn ON the monitor.
3. Connect the USB-C cable from the PC to the monitor.
4. Both the monitor and PC will turn ON normally. If not, press either the monitor
power button or PC power button to boot up the system.
NOTE: Ensure to check the Dell PC for DBPS supportability.
NOTE: When the monitor and PC are both at power OFF state at first time,
it is recommended that you turn ON the monitor first, then connect the
USB Type-C cable from the PC to the monitor.
│
36
Setting up the monitor
USB Type-C
Initial system power state (OFF)
USB Type-C
Initial monitor power state (OFF)
Advertisement
Table of Contents
