Dell Networking S3100 Series Getting Started Manual page 7

Hide thumbs Also See for Networking S3100 Series:

Table of Contents

CAUTION: Do not use the mounted ReadyRails as a shelf or a

workplace.

NOTE: The illustrations in this document are not intended to represent a

specific switch.

1U Tool-less Configuration

To install the Dell ReadyRails system using the 1U tool-less configuration,

follow these steps.

With the ReadyRails flange ears facing outward, place one rail between

the left and right vertical posts. Align and seat the back flange rail pegs in

the back vertical post flange. To see how the pegs appear in both the

square and unthreaded round holes, see item 1 in the following figure.

Align and seat the front flange pegs in the holes on the front side of the

vertical post.

Repeat this procedure for the second rail.

To remove each rail, pull on the latch release button on each flange ear

and unseat each rail.

Figure 1. 1U Tool-less Configuration

Two-Post Flush-Mount Configuration

To install the Dell ReadyRails system using the two-post flush-mount

configuration, follow these steps.

For this configuration, remove the castings from the front side of each

ReadyRails assembly. See item 1 in the following figure. Use a Torx driver

to remove the two screws from each front flange ear (on the switch side

Installation

Table of Contents

Networking s3124