Table of Contents
Advertisement
After powering on the S4100–ON Series switch, it goes through a power-on self-test (POST).
POST runs every time that the switch is initialized and checks the hardware components to determine if the switch is fully
operational before booting. After POST, the switch uses the Grub bootloader.
To select an entry, use the up and down arrow keys. Press Enter to select an operating software (OS) or enter e to edit the
commands before booting. Enter c for a command line. The selected entry runs automatically in the operating system.
Grub bootloader example
GNU GRUB
version 2.02~beta2+e4a1fe391
+--------------------------------------------------+
|*ONIE: Install OS
| ONIE: Rescue
| ONIE: Uninstall OS
| ONIE: Update ONIE
| ONIE: Embed ONIE
| EDA-DIAG
|
|
|
|
|
|
+--------------------------------------------------+
Your switch comes with ONIE installed.
NOTE:
To access ONIE, use the RJ45 console port.
ONIE example
ONIE: Install OS
For downloading and installing an OS from a URL
Starts ONIE with ONIE Discovery Service
(factory default boot)
ONIE: Rescue
Starts ONIE without ONIE Discovery Service
Useful for running Diagnostics manually
ONIE: Uninstall OS
Restore to factory defaults erases any installed OS
ONIE: Update ONIE
For downloading and updating ONIE from a URL
ONIE: Embed ONIE
For downloading and updating ONIE from a URL and erases any installed OS
During the initial setup, the switch boots to ONIE Install. ONIE Install boots with ONIE Discovery to the console (ONIE:).
NOTE:
For more information, see the Open Networking Hardware Diagnostic Guide found at the following sites:
● S4148F-ON, S4148T-ON, S4148FE-ON:
● S4128T-ON, S4148T-ON:
● S4148U-ON:
www.dell.com/support/S4148U
Before you install an OS
www.dell.com/support/S4148F-ON/S4148T-ON/S4148FE-ON
www.dell.com/support/S4128T-ON/S4148T-ON
|
|
|
|
|
|
|
|
|
|
|
|
Before you install an OS
8
41
- Quick Links:
- Rs-232 Console Port Access
Hide quick links:
Advertisement
Table of Contents
