Table of Contents
Advertisement
Final steps
Follow the steps listed below to complete the installation:
•
•
•
Installing a BigIron RX-16 switch
This section describes the following tasks:
•
•
•
•
•
•
•
•
•
Preparing the installation site
Cabling infrastructure
Ensure that the proper cabling is installed in the site.
For information on cabling, refer to
page 54,
switch"
Installation location
Before installing the switch, plan its location and orientation relative to other devices and
equipment. For cooling purposes, allow a minimum of six inches of space between the sides, front,
and the back of the chassis and walls or other obstructions. If a chassis is installed within a
perforated enclosure, the perforations must have openings of at least 60 percent of the surface.
If you will be using a mechanical lift to move and install the chassis, make sure you allow enough
working room.
BigIron RX Installation Guide
53-1001811-01
"Attaching a management station"
"Powering-on the power source"
"Verifying proper operation"
"Preparing the installation site"
"Unpacking a BigIron RX-16 switch"
"Chassis lifting guidelines for BigIron RX-16 switches"
"Installing a BigIron RX-16 chassis in a rack"
"Installing BigIron RX-16 modules"
"Installing power supplies in a BigIron RX-16 chassis"
"Connecting AC power to a BigIron RX-16 chassis"
"Connecting DC power to a BigIron RX-16 chassis"
"Final steps"
"Attaching a management station"
on page 105.
Installing a BigIron RX-16 switch
"Installing power supplies in a BigIron RX-16 chassis"
on page 77, and
"Connecting a BigIron RX Series
2
on
47
Advertisement
Table of Contents
