Table of Contents
Advertisement
1
2
Jam
Toner
Y
M
C
-
Printing a Device Settings Page
Press and hold the
(ready status) until the Ready/Data indicator blinks.
Resetting Defaults
After executing this function and rebooting the printer, all the menu
parameters are reset to their default values.
1 Turn off the printer.
2 Open the rear cover.
3 While holding down the
same time, turn on the printer.
4 After the Orange LED on the Ready/Data indicators go out, release the
(Start) and
5 Close the rear cover.
•
Initializes the non-volatile memory (NVM).
CAUTION:
function.
The printer restarts automatically to apply the settings and prints the
printer settings and device settings pages.
6 Check if the factory settings are restored by referring to the Printer
Settings and Device Settings pages.
3
4
5
Error Ready/
Start Manual
Data
K
-
-
Start) button when the Ready/Data indicator lights
(
(Start) and the
(Cancel) buttons.
Never attempt to turn off the printer. The printer will cease to
7
8
Load
Duplex
Paper
An error occurred while
downloading the firmware.
Turn off the printer, and then
on.
(Cancel) buttons at the
Operator Panel
Cause/Remedy
77
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
