Table of Contents
Advertisement
4-44 System Configuration
Pins for protecting/clearing the password
Short-circuiting the two pins: Clears the password
Opening the two pins:
Pins for protecting/clearing the CMOS data
Short-circuiting the two pins: Clears the CMS data
Opening two pins:
The following describe the clearing procedure.
Observe the following instructions to use the server safely. There are risks of
death or serious personal injury. See "PRECAUTIONS FOR SAFETY" in
Chapter 1.
How to Clear CMOS
Power off the NEC Express5800/ft series and unplug the both power cords.
1.
Remove the both CPU/IO modules (0 and 1) from the NEC Express5800/ft series (see
2.
"Removing CPU/IO Module" on page 8-11).
Make setting of jumper switch for clearing CMOS of CPU/IO module 0.
3.
Remove the clips from the jumper pins (J57) 2-3 and place them on the jumper pins (J20)
9-10 on the CPU/IO Module 0.
Connect only the power cord of the CPU/IO module 0 and press the POWER switch to
4.
power on.
When POST is completed after the startup, press the POWER switch to power off, and
5.
then disconnect the power cord from the outlet.
Protects the password (factory-set)
Protects the CMOS data (factory-set)
Do not disassemble, repair, or alter the server.
WARNING
Advertisement
Table of Contents
Troubleshooting
