What Does Iscsi Optimization Do; How Does The Switch Detect Iscsi Traffic Flows; How Is Quality Of Service Applied To Iscsi Traffic Flows - Dell PowerConnect 8024 User Configuration Manual
Hide thumbs
Also See for PowerConnect 8024:
- User configuration manual (1294 pages) ,
- Cli reference manual (1132 pages) ,
- User manual (778 pages)
Table of Contents
Advertisement
What Does iSCSI Optimization Do?
In networks containing iSCSI initiators and targets, iSCSI Optimization
helps to monitor iSCSI sessions or give iSCSI traffic preferential QoS
treatment. Dynamically-generated classifier rules are used to direct the iSCSI
data traffic to queues that can be given the desired preference characteristics
over other data traveling through the switch. This may help to avoid session
interruptions during times of congestion that would otherwise cause iSCSI
packets to be dropped. However, in systems where a large proportion of traffic
is iSCSI, it may also interfere with other network control-plane traffic, such as
ARP or LACP.
The preferential treatment of iSCSI traffic needs to be balanced against the
needs of other critical data in the network.
How Does the Switch Detect iSCSI Traffic Flows?
The switch detects iSCSI session establishment and termination packets by
installing classifier rules that trap iSCSI protocol packets to the CPU for
examination. Devices that initiate iSCSI sessions generally use well-known
TCP ports 3260 or 860 to contact targets. When iSCSI optimization is
enabled, by default the switch identifies IP packets to or from these ports as
iSCSI session traffic. You can configure the switch to monitor traffic for
additional port numbers or port number-target IP address combinations, and
you can remove the well-known port numbers from monitoring. You can also
associate a target name with a configured target TCP port entry.
How Is Quality of Service Applied to iSCSI Traffic Flows?
The iSCSI CoS mode is configurable and controls whether CoS queue
assignment and/or packet marking is performed on iSCSI traffic. When the
iSCSI CoS mode is enabled, the CoS policy is applied to packets in detected
iSCSI sessions. When the iSCSI CoS mode is disabled, iSCSI sessions and
connections are detected and shown in the status tables, but no CoS policy is
applied to packets.
You can configure whether the iSCSI optimization feature uses the VLAN
priority or IP DSCP mapping to determine the traffic class queue. By default,
iSCSI flows are assigned to the highest VLAN priority tag or DSCP value
mapped to the highest queue not used for stack management or voice VLAN.
Use the classofservice dot1p-mapping command or the Quality of Service →
388
Configuring iSCSI Optimization
- Quick Links:
- Multiple Management Options
Hide quick links:
Advertisement
Table of Contents
