Related Manuals for Nokia RH-20 Series
Summary of Contents for Nokia RH-20 Series
- Page 1 Customer Care Solutions RH-20 Series Transceivers RH-20 Disassembly and Assembly Instructions Nokia Corporation. Issue 1 10/2003...
- Page 2 RH-20 Company confidential RH-20 Disassembly and Assembly Instructions CCS Technical Documentation Table of Contents Page No Disassembling RH-20 ....................3 Assembling RH-20....................... 10 Disassembly and Reassembly Instructions for Camera Module........17 Nokia Corporation. Page 2 Issue 1 10/2003...
- Page 3 - Protect the LCD with a foil whenever possible 1. Place the phone face down, press the Release Key and slide the battery cover downwards. 2. Flip gently the A-cover from down corner. Remove the A-cover. Nokia Corporation. Issue 1 10/2003 Page 3...
- Page 4 RH-20 Company confidential RH-20 Disassembly and Assembly Instructions CCS Technical Documentation 3. Remove the Keymat. 4. Spread the B-cover from both sides until snaps inside will release it. 5. Remove the B-cover. Nokia Corporation. Page 4 Issue 1 10/2003...
- Page 5 Do not touch the antenna plate inside without gloves. 7. Remove the screws (6pcs) to get the module out from C-cover. 8. Remove the module out from the C-cover. Note! Always use the specified tools. Nokia Corporation. Issue 1 10/2003 Page 5...
- Page 6 Be careful not to damage them. 10. Remove the microphone by pressing it from its edge, or take the tweezers between the frame and microphone and lift it out from the frame. Nokia Corporation. Page 6 Issue 1 10/2003...
- Page 7 13. To remove the LCD Module, keep it on a table by using soft cloth, and flip the LCD frame gen- tly until the LCD Module detaches. NOTE! Be careful not to damage the sensitive parts. Do not press the LCD module. Nokia Corporation. Issue 1 10/2003 Page 7...
- Page 8 NOTE! The UI Board is attached into the frame by adhesive tape. Therefore, it may not loose eas- ily. Be careful not to damage the LCD Frame. 15. Remove the Volume Key and the Power Key. 16. Remove the Vibra by lifting it out of its place. Nokia Corporation. Page 8 Issue 1 10/2003...
- Page 9 NOTE! Be careful not to damage the C-cover. 18. Lift the Release Spring by tweezers from its place 19. Remove the Release Key by pressing the snaps towards the center from inside. DISASSEMBLING COMPLETED! Nokia Corporation. Issue 1 10/2003 Page 9...
- Page 10 Reassembly takes place in reversed order compared with disassembly. 1. Press the Release Key downright into its place. 2. Put the Release Spring into its place. 3. Put the DC Jack into its place. Nokia Corporation. Page 10 Issue 1 10/2003...
- Page 11 RH-20 Disassembly and Assembly Instruc- 4. Put the Vibra into its place. NOTE! Avoid touching the spring contacts. 5. Put the Volume Key into its place. 6. Put the Power Key into its place. Nokia Corporation. Issue 1 10/2003 Page 11...
- Page 12 NOTE! Do not touch the inside of the Antenna plate. 8. Put the UI Board into its place. 9. Place the LCD to the UI Frame. NOTE! Do not press the LCD as it may damage. Nokia Corporation. Page 12 Issue 1 10/2003...
- Page 13 Make sure the shield is properly locked on both sides to the frame. 11. Put the Speaker into the frame so that the guiding pin goes into its place. 12. Put the Microphone into the frame. NOTE! Do not touch the spring contacts. Nokia Corporation. Issue 1 10/2003 Page 13...
- Page 14 13. Place the UI Module and the engine together by closing the Display connector. 14. Put the unit into the C-cover. 15. Tighten the six screws by using following order. NOTE! Set 20Ncm/650rpm to your Torque driver before tightening. Nokia Corporation. Page 14 Issue 1 10/2003...
- Page 15 16. Place the B-cover into its place. Make sure the snaps on both sides are locked to the module. 17. Place the Keymat into its place. 18. Place the A-cover into its place. Nokia Corporation. Issue 1 10/2003 Page 15...
- Page 16 RH-20 Company confidential RH-20 Disassembly and Assembly Instructions CCS Technical Documentation 19. Slide the Battery cover into its place until the Release Key locks it. ASSEMBLING COMPLETED! Nokia Corporation. Page 16 Issue 1 10/2003...
- Page 17 Do not touch contacts and camera lens. Use always marking shows to right side when assembling. SRT-10 for assembly and disassembly. Shift the SRT-10 into the camera groove. Take the Camera Module carefully and note the marking. Nokia Corporation. Issue 1 10/2003 Page 17...
- Page 18 Put the Connector Shield on the camera guidance and Check, that Camera Module is clean. When it is necessary press it down. to clean the Camera lens, use compressed air for this procedure only. Nokia Corporation. Page 18 Issue 1 10/2003...