Table of Contents
Advertisement
Steps
1. Align the screws on the system fan with the screw holes on the system board.
2. Replace the four (M2x5) screws to secure the system fan to the chassis.
3. Connect the system fan cable to the connector on the system board.
4. Route the system fan cable through the routing guide on the system fan.
Next steps
1. Install the
SSD
heat-sink.
2. Install the
display
assembly.
3. Install the stylus.
4. Install the batteries.
5. Install the
system
cover.
6. Install the
battery cover
7. Follow the procedure in
Solid-state drive
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in
42
Field service information
assembly.
after working inside the
tablet.
before working inside the
tablet.
Advertisement
Table of Contents
