Table of Contents
Advertisement
Micro serial port and power connector port
Removing micro serial port and power connector port
Prerequisites
1. Follow the procedure in
2. Remove the
batteries cover
3. Remove the
system
cover.
4. Remove the batteries.
5. Remove the
display
assembly.
About this task
The figure indicates the location of the micro serial port and power connector (DC-in) port and provides a visual representation
of the removal procedure.
Steps
1. Disconnect the DC-in cable from the connector and remove the (M2x5) screw that secures the system board to the system
chassis.
2. Lift the latch, and disconnect the micro serial port cable from the connector.
3. Remove the four (M2x5) screws and two (M1.6x5) screws that secure the metal bracket to the system chassis.
4. Lift and remove the metal bracket from system.
5. Remove the (M2x5) screw that secures the DC-in port and serial port to the system chassis.
66
Field service information
before working inside the
assembly.
tablet.
Advertisement
Table of Contents
