Installing The Base Cover - Dell Precision 5570 Service Manual

Hide thumbs Also See for Precision 5570:

Table of Contents

3. Grasp the left side and the right side of the base cover and remove the base cover from the palm-rest and keyboard

assembly.

CAUTION:

Handle with care as the underside of the base cover has pins for grounding the audio board. After

removing the base cover, place it in a location where contact can be avoided.

NOTE:

The following steps are applicable only if you want to further remove any other component from your computer.

NOTE:

Disconnecting the battery cable, removing the battery, or draining the flea power clears the CMOS and resets

the BIOS settings on your computer.

NOTE:

After your computer is reassembled and powered on, it prompts for the Real Time Clock (RTC) reset. When

the RTC reset cycle occurs, the computer restarts several times and then an error message is displayed– "Time of

day not set". Enter the BIOS when this error appears and set the date and time on your computer to resume normal

functionality.

4. Disconnect the battery cable from the system board.

5. Turn your computer over and press the power button for 15 seconds to drain the flea power.

Installing the base cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the base cover and provide a visual representation of the installation procedure.

Removing and installing components

Table of Contents

Show Quick Links

Table of Contents

P91f