Installing The Display Assembly - Dell Precision 5570 Service Manual
Hide thumbs
Also See for Precision 5570:
- Service manual (145 pages) ,
- Setup and specifications (25 pages) ,
- Connection manual (11 pages)
Table of Contents
Advertisement
Steps
1. Loosen the three captive screws that secure the display-assembly cable bracket to the system board.
2. Lift the display-assembly cable bracket off the system board.
3. Remove the two screws (M1.6x3) that secure the display-assembly cable holder to the palm-rest and keyboard assembly.
4. Disconnect the touchscreen cable and camera cable.
5. Remove the eight screws (M2.5x5.5) that secure the left and right display-assembly hinges to the system board and the
palm-rest and keyboard assembly.
6. Slide the palm-rest and keyboard assembly from the display assembly.
7. After performing all the above steps, you are left with display assembly.
NOTE:
The display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is
removed from the bottom chassis. If any components in the display assembly are malfunctioning and need to be
replaced, replace the entire display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display-assembly cable and display-assembly hinges and provide a visual
representation of the installation procedure.
Removing and installing components
41
- Quick Links:
- Solid-State Drive
- Entering Bios Setup Program
Hide quick links:
Advertisement
Table of Contents
