Area Virtual-Link Hello-Interval - Dell Networking 7048 Reference Manual
Powerconnect 7000 series systems
Hide thumbs
Also See for Networking 7048:
- Release note (74 pages) ,
- Configuration manual (1270 pages) ,
- Reference manual (17 pages)
Advertisement
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the dead interval for the area 10 OSPF
virtual interface on the virtual interface and neighbor router.
console(config-router)#area 10 virtual-link
192.168.2.2 dead-interval 655555
area virtual-link hello-interval
Use the area virtual-link hello-interval command in Router OSPF
Configuration mode to configure the hello interval for the OSPF virtual
interface on the virtual interface identified by the area ID and neighbor ID.
Use the no form of the command to return the hello interval to the default
value.
Syntax
area-id
area
virtual-link
area-id
no area
area-id — Identifies the OSPF area to configure. (Range: IP address or
•
decimal from 0–4294967295)
neighbor-id — Identifies the Router ID of the neighbor.
•
seconds — Number of seconds to wait before sending hello packets to the
•
OSPF virtual interface. (Range: 1–65535)
Default Configuration
10 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode.
1166
OSPF Commands
neighbor-id
neighbor-id
virtual-link
seconds
hello-interval
hello-interval
- Quick Links:
- Dhcp Snooping
Hide quick links:
Advertisement
Chapters
