Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for NEC Express5800/120Mc2
Summary of Contents for NEC Express5800/120Mc2
- Page 1 System Release Notes Express5800/120Mc2 System Release Notes PN: 455-01575-002...
- Page 2 Since implementation by customers of each product may vary, the suitability of specific product configurations and applications must be determined by the customer and is not warranted by NEC Computers Inc. To allow for design and specification improvements, the information in this document is subject to change at any time, without notice.
-
Page 3: Table Of Contents
Express5800/120Mc2 System Release Notes The Express5800/120Mc2 System Release Notes provide up-to-date information on your system. These notes also provide additional valuable information about your system that was not included in the user’s guide. Please read these notes in their entirety. -
Page 5: Introduction
Protocol IP settings to obtain an IP address automatically (DHCP), regardless of the setting specified in EasySetup. After installation, the Windows 2000 Device Manager may show an NEC GEM SCSI Processor Device and/or an Unknown Device under Other Devices. The Unknown Device is referenced on the baseboard management controller. -
Page 6: System Element Monitoring
WARNING: Cannot connect to APM, error 0x0036 System loaded, press <Return> to start: To prevent the WARNING message from appearing, boot the system to single- user Mode. Edit the /etc/default/boot file. Add "apm.check=no" to the end of the line indicated by the "DEFBOOTSTR=" entry. 4 Express5800/120Mc2 System Release Notes... -
Page 7: System Hardware
"Disabled". To enable them, the USB Controller feature in the Peripheral Configuration Submenu of the BIOS Setup Utility "BIOS Setup Configuration Settings" must be changed to "Enabled". Refer to Chapter 3 of your User’s Guide. Your User’s Guide is included on ExpressBuilder. Express5800/120Mc2 System Release Notes 5...