Removing A Cd/Dvd Drive - Dell OptiPlex GX60 System User's Manual
Hide thumbs
Also See for OptiPlex GX60:
- Setup and quick reference manual (208 pages) ,
- Setup and quick reference manual (95 pages)
Table of Contents
Advertisement
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next
computer start-up:
ALERT! Cover was previously removed.
11.
Reset the chassis intrusion detector
NOTE:
If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.
12. Verify that your computer works correctly by running the
CD/DVD Drive
CAUTION:
Before you begin any of the procedures in this section, follow the
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1. Follow the procedures in
"Before You
2. If you are installing a new CD/DVD drive rather than replacing a drive,
Removing a CD/DVD Drive
1. Disconnect the power, audio, and CD/DVD drive cables from the back of the drive.
2. Disconnect the other end of the CD/DVD drive cable from the system board connector (IDE2).
1 power cable
2 audio cable
3 CD/DVD drive cable
4 IDE2 connector
3. Press inward on the two tabs on the sides of the drive, and then slide the drive upward and remove it from the drive bay.
by changing Chassis Intrusion to Enabled or Enabled- Silent.
Dell
Diagnostics.
Begin."
remove the front-panel
safety instructions.
inserts.
- Quick Links:
- Booting to a Usb Device
Hide quick links:
Advertisement
Table of Contents
