Solving Problems; Battery Problems; Card Problems - Dell OptiPlex GX60 System User's Manual
Hide thumbs
Also See for OptiPlex GX60:
- Setup and quick reference manual (208 pages) ,
- Setup and quick reference manual (95 pages)
Table of Contents
Advertisement
Back to Contents Page
Solving Problems
Dell™ OptiPlex™ GX60 Systems User's Guide
Battery Problems
Card Problems
Clearing NVRAM and Restoring Default Settings
Diagnostic Lights
Drive Problems
Error Messages
Keyboard Problems
Lockups and Software Problems
Memory Problems
Battery Problems
Fill out the
Diagnostics Checklist
as you complete these checks.
CAUTION:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type
recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.
CAUTION:
Before you begin any of the procedures in this section, follow the
Replace the battery —
If you have to repeatedly reset time and date information after turning on the computer, or if an incorrect time or
date displays during start-up,
replace the
Card Problems
Fill out the
Diagnostics Checklist
as you complete these checks.
CAUTION:
Before you begin any of the procedures in this section, follow the
Check the card seating and cable —
1.
Turn off the computer and devices, disconnect them from their electrical outlets, wait 10 to 20 seconds, and then open the computer
cover.
2.
Ensure that each card is firmly seated in its connector. Reseat any loose cards.
3.
Ensure that all cables are firmly connected to their corresponding connectors on the cards. If any cables appear loose, reconnect
them.
For instructions on which cables should be attached to specific connectors on a card, see the card's documentation.
4.
Clo se the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
Test the graphics card —
1.
Turn off the computer and devices, disconnect them from their electrical outlets, wait 10 to 20 seconds, and then open the computer
cover.
2.
Remove all cards except the graphics card.
If your primary hard drive is connected to a drive controller card and not to one of the system board IDE connectors, leave the drive
controller card installed in the computer.
3.
Close the comp uter cover, reconnect the computer and devices to electrical outlets, and then turn them on.
4.
Run the
Dell
Diagnostics.
Test the cards —
1.
Turn off the computer and devices, disconnect them from their electrical outlets, wait 10 to 20 seconds, and then open the computer
cover.
2.
Reinstall one of the cards that you removed previously.
3.
Close the computer cover, reconnect the computer and device s to electrical outlets, and then turn them on.
4.
Run the
Dell
Diagnostics.
If any of the tests fail, the card you just reinstalled is faulty and needs to be replaced.
5.
Repeat this process until you have reinstalled all cards.
Clearing NVRAM and Restoring Default Settings
Clear the computer's non-volatile random access memory (NVRAM) and restore the computer's system settings to their default values
battery. If the battery still does not work properly,
Mouse Problems
Network Problems
Power Problems
Printer Problems
Serial or Parallel Device Problems
Sound and Speaker Problems
Video and Monitor Problems
Wet Computer
safety
instructions.
contact
Dell.
safety
instructions.
- Quick Links:
- Booting to a Usb Device
Hide quick links:
Advertisement
Table of Contents
