Table of Contents
Advertisement
Steps
1. Reconnect the touchpad FFC to the touchpad module.
2. Align and place the touchpad module onto the system.
3. Install the two (M2x2) screws to secure the touchpad module to the palmrest.
4. Install the touchpad bracket on the touchpad and secure it using the three (M2x2) screws.
5. Peel back the conductive tape over the touchpad module.
6. Reconnect the touchpad FFC to the system board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Disconnect the
battery
5. Remove the WLAN.
after working inside your
before working inside your
cable.
computer.
computer.
Disassembly and reassembly
51
Advertisement
Table of Contents
