Table of Contents
Advertisement
About this task
NOTE:
When replacing/re-installing the power button with fingerprint reader assembly on the Vostro 3501, a mylar sticker
must be adhered to the fingerprint reader FPC to ensure that it is properly grounded to the palm rest. The mylar sticker is
packaged together with new replacement power button with fingerprint reader assemblies
Steps
1. Place the power-button board into the slot on the palmrest.
2. Install the two (M2x3) screws to secure the power button to the palmrest.
3. Connect the power button cable to the connector on the system board.
Next steps
1. Install the
IO
board.
2. Connect the
battery
cable.
3. Install the
base
cover.
4. Install the
SD
card.
5. Follow the procedure in
System board
Removing the system board - Realtek audio
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the battery.
5. Remove the WLAN.
6. Remove the SSD.
68
Disassembly and reassembly
after working inside your
before working inside your
computer.
computer.
Advertisement
Table of Contents
