Table of Contents
Advertisement
About this task
Steps
1. Align the hard drive with the hard drive bracket and replace the four (M3x3) screws.
2. Connect the interposer to the hard drive.
3. Align and place the hard drive assembly on the palmrest, then replace the three (M2x3) screws to secure the hard drive
assembly to the palmrest.
4. Connect the hard drive cable to the system board and close the latch to secure the cable.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
after working inside your
computer.
Disassembly and reassembly
37
Advertisement
Table of Contents
