Table of Contents
Advertisement
Steps
1. Disconnect the display cable from the connector on the system board.
2. Unthread the display cable and WLAN antenna cables from the routing channels.
3. Open the system to at least 90-degrees and place the system on the edge of a table so that the palm rest is laying flat on
the table and the display assembly is over the edge.
4. Remove the six (M2.5x6) screws securing the display assembly in place.
5. Remove the display assembly from the system.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
Ensure that the hinges are opened to the maximum before replacing the display assembly on the palmrest and
keyboard assembly.
Disassembly and reassembly
53
Advertisement
Table of Contents
